What are the different LED status descriptions for the Myo armband?

Myo has two LEDs which represent the current status of the armband. The following identifies and details the various battery, connection and firmware statuses.

Battery Status

  

Thalmic logo LED: Off
Status LED:            Pulse orange.

Myo is connected to a power source and is charging.

  

Thalmic logo LED: Off
Status LED:            Constant green.

Myo is connected to a power source and is fully charged.

  

Thalmic logo LED: Constant blue.
Status LED:            Flash orange.

Low battery indicator when the Myo is in use or idle.

  

Thalmic logo LED: Off
Status LED:            Off

The battery in Myo is at 0%. Connect to a power source.

Connection Status

 

Thalmic logo LED: Constant blue.
Status LED:            Constant blue.

Myo is connected by Bluetooth and the Sync Gesture has been performed.

 

Thalmic logo LED: Pulse blue.
Status LED:            Constant blue.

Myo is connected by Bluetooth and the Sync Gesture has not been performed.

 

Thalmic logo LED: Constant blue.
Status LED:            Off

Myo is not connected by Bluetooth and the Sync Gesture has been performed. Myo will not enter sleep mode while synced.

 

Thalmic logo LED: Pulse blue.
Status LED:            Off

Myo is not connected by Bluetooth and the Sync Gesture has not been performed. Myo will enter sleep mode after a short period of time.

 

Thalmic logo LED: Off
Status LED:            Off

1) Myo is in sleep mode. Move Myo to wake it.

2) Myo is turned off. Connect to a power source via USB to turn on.

3) The battery in Myo is at 0%. Connect to a power source via USB to charge. 

 

Thalmic logo LED: Flash blue.
Status LED:            Constant blue.

Myo is warming up. It will vibrate when the warm up period is over.

 

Firmware Status

  

Thalmic logo LED: Off
Status LED:            Pulse purple.

Myo is completing the firmware update.

 

Thalmic logo LED: Off
Status LED:            Flash red.

An error has occurred on Myo. Reload the firmware.

  

Thalmic logo LED: Off
Status LED:            Constant red.

An error has occurred on Myo. Contact support@thalmic.com

 

Was this article helpful?
2 out of 2 found this helpful